Back to Technical Resources
Installation & Application

Roofing Underlay Installation Guide

2025-06-01

Step-by-step installation instructions for breathable roofing underlay membranes including best practices and common mistakes to avoid.

Category

Installation & Application

Published

2025-06-01

Pre-Installation

Proper preparation is essential for optimal performance:

  1. Check weather conditions: Do not install in rain or high winds
  2. Inspect roof structure: Ensure battens are secure and properly spaced
  3. Plan membrane layout: Start from eaves and work upward
  4. Gather tools: Utility knife, staple gun, tape measure, chalk line

Installation Steps

Step 1: Start at the Eaves

  • Unroll membrane along the eaves edge
  • Allow 50mm overhang into gutter
  • Secure with staples or nails at 300mm intervals

Step 2: Horizontal Overlaps

  • Minimum 150mm overlap between courses
  • Overlap should face away from prevailing wind
  • Use manufacturer's tape for sealed overlaps if required

Step 3: Vertical Overlaps

  • Minimum 100mm overlap at vertical joints
  • Stagger joints between courses (brick pattern)
  • Do not align vertical joints in adjacent courses

Step 4: Ridge Detail

  • Extend membrane 150mm over ridge
  • Use ridge roll or separate ridge membrane
  • Ensure ventilation gap is maintained

Step 5: Penetrations

  • Cut membrane around pipes and vents
  • Use flashing tape or collars to seal
  • Maintain minimum 100mm overlap on all sides

Common Mistakes to Avoid

  • ❌ Insufficient overlaps leading to water ingress
  • ❌ Installing upside down (check manufacturer's markings)
  • ❌ Blocking ventilation paths
  • ❌ Using wrong fasteners (corrosion risk)
  • ❌ Leaving membrane exposed to UV longer than rated

Quality Control

  • Inspect all overlaps before covering with battens
  • Check for tears or damage and repair immediately
  • Verify ventilation gaps are maintained
  • Document installation with photos